기본 콘텐츠로 건너뛰기

AutoFlexDuct

 App Name : AutoFlexDuct


App Short Description

It makes automatically flexible ducts  between ducts and air terminals.


App Description

It makes automatically flexible ducts  between ducts and air terminals.

Air terminals are connected to nearest duct by flexduct.

Multi ducts and air terminals are availible.

It helps remove modeling time and improve model quality.


General Usage Instructions

1. Select air terminals and ducts.

2. Select flexduct type and click Create button.

3. Each air terminals will connect to nearest duct. 

* Air terminals must have only one connector.






댓글

이 블로그의 인기 게시물

 MEP Up/Down https://youtu.be/8xQfUyhq0BI To avoid a clash, MEP elements (duct, pipe, cable tray, and conduit) need to level up or down. By splitting the elements and input offset/angle value, the app redraws elements to level up or down. The app works with any language version of Autodesk® Revit®, but the command in English. It is useful for Revit HVAC, piping, and electrical modeling. It saves modeling time, improves model quality.   [Note] Available in all languages (Add-in is in English) Unit -> Offset Project Length Unit, Angle: 1~90 degrees. Fittings are referred to as Routing Preference of Type Properties. Offset Value needs enough room to place the required fittings. Convenient to use a plan view when an element is split. Insulation and lining are supported. Fabrication is not supported.
 PlacebyCADblock Place component elements using imported CAD block location automatically. Components' elements are columns, generic models, etc. Imported CAD block is a part of CAD files. This app can reduce modeling time and improve model quality.

CopyElementLayers

  CopyElementLayers This app copies the layer information of wall, floor, roof, and ceiling elements to specific type parameters. These elements have layers, which contain information about function, material, and thickness. Users can set the desired category, layer information, and type parameters. Pressing the Apply button copies these layer information in text form to the selected type parameter. The entered information can be expressed in the drawing by using the tag. This app saves you time annotating to describe the layers of wall, floor, roof, and ceiling elements. Please note that the copied content is not automatically updated when the layer is changed.